Pipe and Tube Supply, Inc.


1. BASE WIDTH           : (inches or millimeters)
2. TOP WIDTH            : (inches or millimeters)
3. HEIGHT DIMENSION     : (inches or millimeters)
4. LEFT SHOULDER        : (inches or millimeters)
5. RIGHT SHOULDER       : (inches or millimeters)
6. LEFT OFFSET          : (inches or millimeters) 
7. KERF DIMENSION       : (width of cutting tool path)
8. SCRAP DIMENSION      : (distance between parts, in/mm)
9. LEADIN DIMENSION     : (inches or millimeters)
10. VERIFY- YES/NO      : (yes or no)


  • Like others, this part is cut with the BASE at the upper position. As a result, the prompts used to label the top and sides assume the part is rotated 180 degrees.
  • The only difference between parts created with LEFT PLATE or RIGHT PLATE enabled occurs in the traverse move to the first pierce point, as shown.
    sales (501)372-6556 * FAX (501)372-7694 * (800)770-8823 * ptsemail@comcast.net